LoadRunner enables you to test IPv6 based applications in addition to IPv4 based ones. Script recording supports recording for both IPv4 and IPv6 simultaneously. The code that is generated is non-IP specific. Except for Web HTTP based protocols, users are unaware of which IP version is being used when replaying the script in a load test. Web HTTP protocols have a Runtime setting that allows you to choose between IPv4 and IPv6 for the replay.
The internal LoadRunner communication between the Controller and Load Generators uses IPv4 communication. To record and replay in both IPv4 and IPv6, install both VuGen and Load Generator on IPv6-enabled computers, as shown in the diagram below.
For more details about IPv6 related changes, see the Preferences View - Internet Protocol.
For a list of the supported protocols, see the support matrix for this version of LoadRunner.
Protocol Support Limitations
Support for IPv6 is available with the following limitations:
- Web HTTP protocol
- FTP from Web is not supported
- Web Breakdown is not supported
- Kerberos is not supported
- Spoofing from Web is not supported
- PAC file is not supported
IPv6 Webtrace is not supported on 6to4 outgoing network interfaces.
IPv6 webtrace does not support RawSocket mode
- General limitations
- Replay failures may occur because of a IPv4/IPv6 switch between recording and replaying.